Engine overheats or leaks coolant

During PE12-016, Chrysler identified a condition in model year (MY) 2011 Chrysler 200 and Dodge Avenger vehicles equipped with 3.6L engines that may result in engine stall when stopped or travelling at very low speeds.According to Chrysler, this condition occurs when the Powertrain Control Module (PCM) initiates a purge monitor check while the engine is at idle which can result in an overly rich vapor condition and cause the engine to stall while stopped.Chrysler developed a software countermeasure to address the condition and has initiated a customer satisfaction campaign to reprogram the PCM on all affected vehicles. The bulletin was sent to dealers on September 28, 2012 and the owner letter mailing began on October 5, 2012.See the investigative file for copies of Chrysler's bulletin and owner letter.The Office of Defects Investigation (ODI) analyzed complaints related to engine stall that were provided by Chrysler or submitted to ODI from consumers.The predominant failure mode identified involved stalling when stopped or travelling at low speeds.The complaint counts shown in this resume include incidents in which enough detail was available to verify the symptoms were related to the defect condition identified by Chrysler.Two complaints alleged engine stall resulting in collisions, one involving very minor damage and one involving a single vehicle road departure crash in which the vehicle was totalled.In the first incident, the vehicle stalled while stopped at an intersect