ABS light on

Risk: Unintended activation of the driveline-protection system will cause unintended braking on the wheel on the opposite side of the failed sensor, causing the vehicle to pull to one side unexpectedly, increasing the risk of a crash.
Remedy: GM will notify owners, and dealers will reprogram the EBCM, free of charge. The recall began December 11, 2019. Owners may contact Chevrolet customer service at 1-800-630-2438 or GMC customer service at 1-800-462-8782. GM's number for this recall is N192261050.

Risk: As the vacuum level drops, the brake assist decreases, increasing braking effort, extending the distance required to stop the vehicle, thereby increasing the risk of a crash.
Remedy: GM will notify owners, and dealers will reprogram the Electronic Brake Control Module, free of charge. The recall began October 8, 2019. Owners may contact Chevrolet customer service at 1-800-630-2438, Cadillac customer service at 1-800-458-8006 or GMC customer service at 1-800-462-8782. GM's number for this recall is N192268490.

On November 20, 2018, the Office of Defects Investigations (ODI) opened PE18-012 to investigate instances of sudden onset of a hard brake pedal that could result in extended stopping distance due to an issue with the brake assist vacuum pump in model year (MY) 2014 through 2016 GMC Sierra 1500 and Chevrolet Silverado 1500 series pickup trucks and MY 2015 through 2016 Cadillac Escalade, Chevrolet Suburban, Chevrolet Tahoe, and GMC Yukon SUVs.If the brake assist vacuum pump fails to operate as intended, the amount of brake power assist supplied to the driver can be significantly reduced, extending the subject vehicle stopping distance. GM stated that the root cause of pump failures was due to foreign debris such as oil sludge in the engine oil. GM stated that this debris can become trapped by the oil inlet filter screen. Under normal operation, this screen allows a small amount of oil into the brake vacuum pump. The foreign debris can, over time, clog the pump which can cause a loss of lubrication and a reduction in the amount of vacuum produced leading to a hard pedal and extended stopping distance.On December 13, 2018, GM issued a Special Coverage (N182202780) for the brake vacuum pump issue in MY 2014-2017 trucks and 2015-2017 SUVs on the K2XX platform for 6 years or 72,000 miles. Special Coverage repair includes the replacement of the vacuum pump and vacuum pump belt. Consumers received notification of the coverage via mail. On September 6, 2019, GM notified NHTSA that it w

On January 11, 2011, ODI opened EA11-001 to investigate allegations of premature brake line corrosion failure in model year (MY) 1999 through 2003 General Motors (GM) full-size pickup trucks and sport utility vehicles sold or registered in the following region of the United States that NHTSA has viewed as salt states for investigations of corrosion related issues:Connecticut, Delaware, District of Columbia, Illinois, Indiana, Iowa, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, West Virginia and Wisconsin.The subject vehicles represent the first five MY's of GM's GMT800 platform production, of which approximately 2,038,504 vehicles were sold in salt states (the subject vehicles).The GMT800 platform includes the following vehicles:1999-2007 Chevrolet Silverado and GMC Sierra 1500, 2500 and 3500 series pick-up trucks; 2000-2006 Chevrolet Suburban, Chevrolet Tahoe and GMC Yukon sport utility vehicles; and 2002-2006 Cadillac Escalade and Chevrolet Avalanche sport-utility vehicles.General Motors produced a total of approximately 10,427,062 GMT800 vehicles for sales in the United States, including almost 5 million that were sold in salt states.Although there are over 60 different brake pipe routing configuration used in GMT800 vehicles, with the exception of the rear crossover pipes in MY 200x-2007 vehicles that changed from rear disc to drum brakes, all of the vehicles use brake pipes f

The Office of Defects Investigation (ODI) received Defect Petition DP10-003 on March 2, 2010, requesting the investigation of model year (MY) 2003 Chevrolet Silverado 2500HD 4WD pickup trucks for corrosion failures of the vehicle brake lines.DP10-003 was granted and on March 30, 2010, Preliminary Evaluation PE10-010 was opened on more than six million model year 1999 through 2003 light trucks and sport utility vehicles manufactured and sold by General Motors Corporation (GM).On July 2, 2010, ODI received GM's response to an information request, which included GM's assessment of the frequency and safety consequences of the alleged defect. GM stated that:(1) the brake system of the subject vehicles is split front/rear and should a brake pipe suddenly fail for any reason, the affected vehicle would be capable of stopping with the pressure supplied by the remaining circuit; (2) the subject vehicles were designed to meet the hydraulic circuit partial failure requirements of Federal Motor Vehicle Safety Standards 105 and 135, Light Vehicle Brake Systems; and (3) should a brake fluid leak occur for any reason, the brake system malfunction indicator lamp (MIL) would illuminate and warn the driver before the brake fluid level was low enough to cause a loss of line pressure.ODI's and GM's analysis indicates that 85 percent of the complaints occurred on vehicles used primarily in States that use salt on the roads during Winter months (Connecticut, Delaware, District of Columbia, Illinoi

IN A LETTER DATED AUGUST 29, 2005, GM NOTIFIED ODI THAT IT WAS RECALLING CERTAIN MODEL YEAR 1999 THROUGH 2002 C/K PICKUP TRUCKS AND SPORT UTILITY VEHICLES TO CORRECT A PROBLEM WITH ANTI-LOCK BRAKE SYSTEM (ABS) WHEEL SPEED SENSOR CORROSION THAT MAY RESULT IN UNWANTED ABS ACTIVATION AND EXTENDED STOPPING DISTANCES DURING LOW-SPEED BRAKING (RECALL 05V-379).GM'S RECALL COVERS APPROXIMATELY 804,000 VEHICLES CURRENTLY REGISTERED IN THE FOLLOWING 14 SALT-BELT STATES:CONNECTICUT, ILLINOIS, INDIANA, MASSACHUSETTS, MAINE, MICHIGAN, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, AND WEST VIRGINIA.THE RECALL PROCEDURE WILL INVOLVE REMOVING THE SENSOR, CLEANING THE MOUNTING SURFACE, APPLYING A RUST INHIBITOR (ZINC-X) TO THE SURFACE, AND REINSTALLING THE SENSOR.IF NECESSARY, THE SENSOR WILL BE REPLACED. THE POPULATION AND FAILURE REPORT DATA GIVEN IN THIS RESUME ARE FOR THE FULL REGION THAT HAS BEEN CONSIDERED BY ODI AS THE SALT-BELT.THAT INCLUDES DELAWARE, IOWA, MARYLAND, MINNESOTA, MISSOURI, WISCONSIN AND THE DISTRICT OF COLUMBIA IN ADDITION TO THE 14 STATES INCLUDED IN 05V-379.THE STATES COVERED BY GM'S RECALL HAVE THE HIGHEST INCIDENT RATES FOR THE SUBJECT CONDITION, ACCOUNTING FOR 91% OF THE INCIDENTS, BUT ONLY 24% OF SUBJECT VEHICLE SALES IN THE UNITED STATES.ODI'S ANALYSIS DETERMINED THAT 840 OF THE COMPLAINTS, 244 OF THE CRASHES, AND 16 OF THE INJURIES IDENTIFIED IN THIS INVESTIGATION OCCURRED IN THOSE STATES.THE RESULTING INCIDENT AND CRASH RATES A

GM IS CONDUCTING A RECALL ON ALL SUBJECT VEHICLES BUILD BETWEEN MAY 1999 AND OCTOBER 14, 1999.SIGNIFICANT CHANGES WERE INCORPORATED INTO PRODUCTION IN EARLY OCTOBER 1999, AND VEHICLES BUILT AFTER THAT DATE HAVE LOWER WARRANTY FAILURE RATES.THE COMPLAINT AND WARRANTY DATA APPEAR TO SUPPORT THE EFFECTIVENESS OF THESE CHANGES. GM MADE ADDITIONAL CHANGES IN NOVEMBER 1999, FEBRUARY 2000, MAY 2001, AND FEBRUARY 2004.ODI WILL CONTINUE TO MONITOR THIS PROBLEM AND WILL TAKE FURTHER ACTION, IF WARRANTED, IN THE FUTURE.FOR FURTHER TECHNICAL DETAILS SEE THE ATTACHED ENGINEERING ANALYSIS REPORT.