Diagsheet

2014 Ford F-250 Super Duty · recalls

2014 Ford F-250 Super Duty recalls

NHTSA lists 1 recall that include the 2014 Ford F-250 Super Duty. It is 20E-090, filed Dec 10, 2020 for the steering system.

  • 1recalls
  • 1systems
  • 164owner complaints

Newest recall or investigation Dec 10, 2020 · checked Sep 22, 2026

Whether your car is included depends on its VIN, and a finished repair drops it off the list. Check yours at nhtsa.gov/recalls.

Every recall, newest first

20E-090Dec 10, 2020NHTSA 20E090000

Steering

Icon Vehicle Dynamics, LLC (Icon) is recalling all 05-UP FSD 2.5 Centerline Stabilizer Kits with part number 65050. The kits were sold as an accessory for certain 2005-2021 Ford F-250 4X4 and F-350 4X4 pickup trucks. The foam ring inside the stabilizer "through shaft" may block the piston ports, possibly causing the steering to lock up.

Risk: If the steering locks, it can increase the risk of a crash.

Remedy: Icon will notify owners, and dealers will install a new shock assembly with a revised foam ring and steel support disc, free of charge. The recall began December 21, 2020. Owners may contact Icon customer service at 1-951-689-4266.

81 of the 164 owner complaints on this car cite the steering system. Symptom sheets that include this system: Steering wheel shakes or the "death wobble" (77).

Complaints with no recall behind them

The systems owners of the 2014 Ford F-250 Super Duty complain about most that none of these recalls covers, as of Sep 22, 2026. A problem can be widespread without being a safety defect NHTSA can order fixed.

NHTSA investigations

RQ14-005opened Jan 13, 2015
Electrical · model years 2011 to 2015

Vehicle commanded engine shutdown. Closed mar 15, 2016, led to recall 15V-175.

NHTSA summary
The Office of Defects Investigation (ODI) opened this RQ to investigate allegations that the scope and remedy of safety recall 13V-535 were inadequate. Recall 13V-535 was limited to a relatively small population of Ambulance Package vehicles and ODI received complaints of pickup trucks and Fire Engine Prep Package vehicles being affected by the same defect. Ford manufactured approximately 555,985 subject vehicles between February 22, 2010 and January 30, 2015 that may be affected by defective EGT sensors and Powertrain Control Module (PCM) software calibration. The subject vehicles are equipped with four (4) EGT sensors to monitor engine operating conditions. An EGT sensor fault may produce false exhaust over-temperature signals. If these signals are produced, the Powertrain Control Module (PCM) implements a Failure Management Effects Mode (FMEM) and the driver receives a Stop Safely Now (SSN) system warning on the instrument cluster message center. The FMEM triggers a 70% reduction in available engine power over a period of no more than 45 seconds, during which it may not be possible to accelerate or maintain vehicle speed. The PCM then commands the engine to shut down when vehicle speed reaches approximately 1 mph. There is no immediate restart capability. Depending on the PCM software calibration, ignition key position and ambient temperature conditions, the engine may not restart until the end of a 10-60 minute cool down period.Ford and its component supplier(s) made nume

More on the 2014 Ford F-250 Super Duty

Problems by mileage on the 2014 Ford F-250 Super Duty · Ford F-250 Super Duty years to avoid

Recalls on other model years